First layer inconsistent issue cause by gantry tilting

[wispy crater]

Apparently the issue is caused by the heat sink I installed on the bottom of the ab motor.... They are hitting the corner bracket I had on the frame and bumping the back side of the gantry up

[verbal rose]

Thanks for sharing the conclusion. can you put the original message back so if anyone searches they can find it and possibly resolve their issue?

[wooden drift]

Hi, you can just hit Close on the thread, or apply Resolved tag rather than deleting the message 🙂
Trust me even the most trivial questions repeat and somebody will run into the same issue 🙂