klipper_kalico_help
BTT pi v1.2 + SKR Pico "The klippy host software is attempting to connect."
Installation
Solved
Connectivity
Flashing
Extrude below minimum temp Error when trying to print
Error messages
Macros
Config
Klipper doesnt see my Mcu
Connectivity
Error messages
Toggles in mailsail ?
Macros
Internal error on command:"G3" / MCU connection lost
Error messages
Issues with initial setup of motor direction with voron 2.4 BTT Octopus.
Config
wifi shows connected but there is no access.
Connectivity
Config
Giving up on Wifi.
Connectivity
LDO switchwire, any attempt to move in any axis results in error
Error messages
Can't get the flash-sdcard.sh script to flash firmware to the Octopus 1.1 board.
Flashing
Klipper reports: SHUTDOWN (temperature issue)
Config
another MCU not connecting, Klipper not ready post
Connectivity
Installation
Flashing
KAMP not working properly
Meshing & probing
ls: cannot access '/dev/serial/by-path/*': No such file or dir
Error messages
How do I gain access to my printer/Klipper from my desktop to fix a config issue.
Error messages
mac stopped finding machine
Connectivity
Error after editing printer.cfg
Error messages
Several different MCU Shutdowns
Error messages
Stuck on this error for Klipper install
Flashing
MCU 'EBB' shutdown: Timer too close
Error messages
TMC5160t plus with a octopus pro board Fixed
Error messages
Config
klipper screen orange pi
Klipperscreen
switchwire bed mesh was working but not anymore.
Solved
Meshing & probing
Bed Mesh Problems not square
Meshing & probing
adaptive bed mesh not meshing
Macros
Meshing & probing
mcu protocol error
Error messages
Changing Klipper repo to a different mirror
Installation
Default Mesh won't load in Klipper
Error messages
Clicked update bttn
Config
Meshing & probing
MCU timer too close
Installation
Connectivity
voron v0.1-s1 klipper install+printer config
Installation
Config
heater_extruder not heating at expected rate in a cold room
Error messages
Config
Klipper Backup Github error
Error messages
M8p v1.1 & sb2209 guide?
Flashing
Can't understand why a valid pin is invalid causing shutdown
Error messages
Config
Solved
Failed MCU update after Klipper update
Installation
Flashing
Tips for utilizing the recent Klipper Adaptive Mesh merge?
Error messages
Macros
Config
Solved
Raspberry Pi camera module 3 and Klipperscreen rotation
Solved
Mainsail OS unable to update anything
Connectivity
Error messages
what would cause my temp target to turn off once temperature stabilize at target ?
Solved
Config
TMC2240 temperature sensor for fan control
Error messages
Config
NEW! Bed Fans Smart Monitoring Control System
Macros
How to set 00 position but go beyond in y (-5y) for use with decontaminator
Config
MCU-Z missing after updates...?
Error messages
Flashing
Fly ADXL345
Flashing
Gcode shell sript error
Error messages
Solved
Z offset (first layer) changes between prints
Macros
Config
Flashing Klipper FW to SKR 1.3 unresponsive
Flashing
issue with two mcu on one printer
Installation
Config
Flashing
Issue with the BTT SFS
Macros
Config
Extruder thermistor reading incorrectly
Solved
Config