klipper_kalico_help
Sensorless homing klipper not following the sensitivity set in printer.cfg
Solved
Config
Mcu help
Connectivity
Error messages
Config
Lost klipper on board after getting CAN working
Flashing
Homing Direction
Config
Base config for formbot kit 350*350
Config
Intermittent failure to boot? after restart/firmware restart or even hard reset.
Installation
Troubles with MCU Update
Flashing
Start gcode configuration issues
Error messages
Solved
Yet another timer is too close...
Error messages
Klipper reports: ERROR mcu 'mcu': Unable to connect
Error messages
Config
TMC 'extruder' reports error: GSTAT: 00000001 reset=1 (Reset)
Error messages
how to fix error dvr status overtemperror
Error messages
The value printer_lights is not valid for PIN
Config
i have to restart my printer every print because if not i get this error on the next one.
Error messages
Moonraker can't connect to klipper
Flashing
Updating MCU to the latest Klipper version
Solved
Flashing
file does not exist
Error messages
webhoook shutdown state
Error messages
MCU 'umb' shutdown: ADC out of range
Connectivity
Went from pi3 to pi4 Used my backup cfg but getting probe name issue
Config
SCREWS_TILT_CALCULATE Error
Solved
Hot End Temperature all over the place
Error messages
Klipper config BTT Octopus Pro with tmc 5160 plus
Config
Mini12864 sleep?
Solved
Config
Adding a second camera
Camera
The value 'extruder_1' is not valid for EXTRUDER
Macros
Using a Klipper printer without wifi
Connectivity
mcu 'mcu': Unable to connect OR mcu 'EBBCan': Unable to connect
Connectivity
Error messages
MainsailOS Raspi-imager problem
Flashing
fly gemini v3
Installation
Config
Flashing
How do I connect to my printer without using Wifi?
Connectivity
Cannot set heater_bed below 70C.
Installation
Aux fans settup
Macros
Hi i building a 2.4 and im having issues flushing out my config
Config
STM32_Mini12864 kill switch
Config
openRGB with klipper
Config
Trying to update ADXL sensor, Perpetual MCU Protocol error
Error messages
Config
Flashing
Heightmap
Config
Meshing & probing
Unknown command in macro
Macros
Python 2 to Python3
Installation
After Klipper update the printer wont start.
Error messages
Bought a voron and I'm having trouble setting it up
Installation
Issues with klipper config.
Error messages
Trouble flashing klipper on Octopus
Clicked update bttn
Flashing
Section 'menu __main __control __auxfanonoff' is not a valid config section
Error messages
Config
Config files not appearing after updating Klipper
Config
Flashing
weird mpu6050 behavior
Error messages
printer is not ready after adding input shaping config to printer.cfg
Config
klipper screen help
Installation
Klipperscreen
klipperscreen won't boot anymore, it's stuck in a bootloop since an update
Klipperscreen