klipper_kalico_help
Need Help designing a macro for chamber heating with bed fans.
Macros
Config
New Ldo 2.4 will not home
Meshing & probing
Error when shutting down
Error messages
Mainsail will not boot.
Connectivity
Config
Flashing
MPC Heating Slow, Modeled Temperature Rises Faster than Measured Temperature
Config
How to I find printer settings to use in a macro?
Macros
klipper fan speed setting confusion
Macros
Install Klipper
Installation
Hiring Remote Tech for Voron Klipper Setup
Installation
Error messages
Macros
Config
TMC stepper_z1 failed to init error
Clicked update bttn
high CPU load on idle (RK3328, libre computer renagade 4GB)
Installation
update got me again
Installation
Error messages
crowsnest sees USB camera, maisail navigation does not show webcams
Installation
Camera
Klipperscreen
Config
Has anyone gotten the btt HDMI5 v1.2 display working on a CB2 with armbian?
Installation
Setting up a time-limited effect with klippper-led_effect
Macros
Config
Klippy.log Grew to 9.2 GB and Filled CB1 Storage
Error messages
FYSETC Spider V3.0 - Klipper connection issue
Connectivity
Installation
Error messages
Solved
G28 X sets both X and Y in printer.homed_axes
Macros
Flashing katapult to Leviathan no /dev/serial
Installation
Solved
Flashing
Understanding the Install Process for Headless CAN setup
Installation
Solved
Micron R1 X "bounceback" on Y sensorless homing
Config
Timeout error on homing X axis and occasionally Z axis
Error messages
Klipper screen no longer working
Klipperscreen
Possible Klipper Issue w/ Nevermore Stealthmax after Updates
Error messages
Solved
Cant update or install git on raspberry pi
Installation
Solved
Clicked update bttn
Heaters shutdown after print start macro
Macros
Config
[Solved] Unable to read tmc uart ‘stepper_z’
Connectivity
Error messages
Config
Solved
Random error during Print “Can not update MCU ‘mcu’ config as it is shutdown”
Error messages
Heater bed causing prints to fail and quit early
Error messages
ADC out of range error for mcu temp when stepper motors engaged.
Connectivity
Error messages
Z Offset via macro
Solved
Macros
Meshing & probing
Lost communication - only during filament change, any MCU
Error messages
Loadcell as probe
Solved
Macros
Config
Meshing & probing
Looking to rebuild my config and macros file to be less of a mess. Would this be the right place?
Solved
Macros
Config
timer too close after upgrading to v0.13
Error messages
New native Eddy Tap Klipper Issues
Macros
Meshing & probing
Random mcu communication error’s
Connectivity
How to set up PRINT_START macro
Solved
Ebb loosing connection
Error messages
Need help with Filamatrix Cutting macros
Macros
Something wrong with my print_start
Macros
Printer hard powering off when running a preheat macros thats works for years.
Macros
Must home axis first when homing after print cancel
Error messages
Config
Keypad e-stop button not firing until current command is completed
Macros
Config
klipper error with nighthawk board gpio
Connectivity
Solved
UART on Octopus + RPi 3B+
Installation
Flashing
Issues installing klipperscreen
Solved
Klipperscreen
z-tilt allway blue
Config
Klipper sensorless homing error
Config
Mellow Fly ERCF V1.2 Firmware
Flashing