voron_2_help_forum_public
Printer randomly shuts down
First print
Solved
Unable to get chamber temps over 39C
Tuning
LDO Trident Kit - Failing to flash to update Klipper
Electronics & wiring
Configuration
Keeps on shutting down,
Printer shutdown
Wet filament?
First print
Solved
Filament getting stuck at hotend
Mechanical
Solved
Klicky probe, QGL, tolerance way off. (V2.4)
QGL
MCU 'mcu' has deprecated code
Solved
Electronics & wiring
hi all i am new..
Solved
MCU 'sb2209' shutdown: Timer too close
Electronics & wiring
My formbot 2.4 kit cant print straight up/leaning left
Mechanical
First print
What is causing this to happen?
Printer shutdown
Issues with Front Right and Rear Left corners.
Mechanical
First layer
QGL
Layer 2 severe under-extrusion/gaps on V2.4 350 - ASA
First print
Solved
Defekter Voron
Mechanical
Electronics & wiring
Configuration
Safely remove/replace the ceramic heaters from hotends?
Mechanical
Electronics & wiring
Sb_can_th error
Electronics & wiring
CAN issues after replacing toolhead board
Electronics & wiring
Configuration
Klicky Auto Z Calibration
Z Offset
Solved
Configuration
I get this holes on the surface layer.
First print
How do I cut the screw holes on the magnetic pad?
Kits/parts advice
Mechanical
Help a noob
Tuning
Toolhead not extruding consistently
Kits/parts advice
Initial setup
Solved
X beam
Kits/parts advice
Mechanical
Layer shift, physical contact
Mechanical
Hi,
Configuration
XY belt Install
Mechanical
Inaccurate x and y dimensions on newly built LDO Voron 2.4 350.
Initial setup
LDO Motors Voron 2.4 r2 Rev D 350mm build - Voron Kilpper config setup - Z Endstop Triggered
Initial setup
Solved
Voron 2.4R2 PROBE_ACCURACY
Tap
Initial setup
weird movement of tool head and sequence
Configuration
Rapido2 plus HF in FilamAtrix
Mechanical
Electronics & wiring
Nozzle evenly dragging on print bed
Tuning
Z Offset
First layer
Tap
Solved
Doing the right driver value for sensorless homing.
Tuning
Configuration
sensorless homing wrong direction and strange error
Initial setup
Solved
Electronics & wiring
Configuration
Massive layer shif
Tuning
Mechanical
Hot end temperature is high on boot
Initial setup
Voron 2.4 documentation issues
Mechanical
Kits/parts advice
Heater not heating
Mechanical
Electronics & wiring
Siboor Voron 2.4 R2 Build Weird Print Issue
Initial setup
First print
Quad gantry leveling being weird
Tuning
Electronics & wiring
QGL
Solved
Configuration
Manta M8P v2 + CM4 fried?
Printer shutdown
Mcu disconnects issue (again)
Printer shutdown
Sensorless Homing settings
Tuning
Configuration
Manta M8P v2.0 and CM4 Lite booting issue
Initial setup
Formbot umbilical routing??
Kits/parts advice
Solved
Electronics & wiring
Format wiring
Electronics & wiring
Layer shift along X and Y at third layer
Tuning
Mechanical
Initial setup
First print
Box corners not beautifull
Tuning
eddy duo error: Existing config autosave is corrupted. Can't complete SAVE_CONFIG
Tap
Solved