voron_2_help_forum_public
Help with print quality?
Tuning
Help with speed tuning
Tuning
How do i find my mcu 'nhk' serial?
Initial setup
Solved
Configuration
Voron 2.4 configuration issues ...again
Solved
Configuration
Voron 2.4 Dragon UHF Screw Issue
Mechanical
Z Endstop Questions
Mechanical
Solved
stuck at configuration
Solved
Configuration
Filters stronger than the nevermore?
Mechanical
Kits/parts advice
Configuration
350mm Y Axis increase?
Kits/parts advice
Mechanical
Configuration
Color of framing
Kits/parts advice
New build 2.4 r2
Kits/parts advice
Electronics & wiring
Timer Too Close as soon as print loads, every single time with this one file.
Printer shutdown
Problems with Extruder Motor
Mechanical
Initial setup
Electronics & wiring
No WiFi or SSH.
Printer shutdown
Hum Noise Around Edge
Mechanical
Pressure Advance Stopped Working out of the Blue
Tuning
Mechanical
Bambu Hot End
Kits/parts advice
Voron Stealthburner
Mechanical
Solved
Beacon with Manta M8Pv2 and SB2209/RP2040
Kits/parts advice
Solved
Electronics & wiring
Formbot 2.4R2 (2022) 350mm ChaoticLabs CNC Tap Belt Question
Mechanical
Issues with printing flat
Tap
First layer
Solved
Formbot 2.4R2 (2022) 350mm Gantry Squaring / Racking Issue.
Mechanical
Trident LDO Kit and Rapido HF Hotend
Kits/parts advice
Electronics & wiring
Configuration
[solved] beginning of lines on first layer curl up???
Tuning
First layer
Solved
I keep having problems with the first layer
Bed mesh issue
Z Offset
First layer
QGL
V2.4-350 skirt fitment
Mechanical
Kits/parts advice
Solved
2.4 AWD Configuration
Electronics & wiring
Configuration
Motors broke? Hard to turn
Mechanical
Electronics & wiring
Good usb hub
Electronics & wiring
Problem with the bed
Bed mesh issue
Can't get ebb36 to show up with lsusb
Printer shutdown
Electronics & wiring
scratching noises from A motor assembly and L front idler
Mechanical
Initial setup
filament jamming (maybe) - filament path binding in the toolhead
Mechanical
FYSETC CNC gantry XY joint idlers issue
Mechanical
Voron V2 LDO 2.4 V3 build, having issues with gantry does not fit correctly?
Mechanical
TFT43 v2,1 Voron 2.4 Frontskirt Mount
Kits/parts advice
Bought Used 2.4, Looking for new toolhead,extruder and hotend and general help
Kits/parts advice
Mechanical
CM4 upgrade
Configuration
CANBUS issues
Electronics & wiring
G2E slipping
Tuning
Mechanical
Initial setup
Printer was fine, now the thermistor reading is reading 360 when plugged in, 70 when unplugged.
Printer shutdown
Formbot Voron 2.4 R2 Pro+ and ChaoticLab Tap V2
Initial setup
slight Y move on pure X
Mechanical
problem with QGL seams like during procedure oneztepper is not working (Z0)
Electronics & wiring
Kits/parts advice
QGL
Configuration
Nitehawk config help
Tuning
Formbot kit, which experience is required? Which parts should I print?
Kits/parts advice
getting weird prints
Mechanical
First 2.4 with or without cartographer
Kits/parts advice
Manta m8p and cb2
Electronics & wiring
Incorrect movement in two different printers
Tuning
Mechanical