late eagle
Battery died in 2017 F-150 LTX, replaced it and didn't know about the battery reset thing with the left stick 5 times & break 3 times until later but I did it and it drives and I can use tow mode and sport mode but there's error codes/wrench light. I tried checking a relay or two and nothing looked burnt out or anything. Any ideas what to try?
proud pilot
Take it to a dealer is what I’d do. That’s a lot of codes for just swapping a battery…
late eagle
Take it to a dealer is what I’d do. That’s a lot of codes for just swapping a ba...
I probably don't have the money for that
proud pilot
Well, then your probably SoL
late eagle
I'm hoping its something simple, like a bad relay or something i did
proud pilot
Well, I know the Starter code is a Starter Performance code related to the Starter not being able to use Start/Stop.
late eagle
Oh its not a wrench its just check engine light
proud pilot
We have a truck in the shop I work at that has that code
And the fix is Replace Starter in our case.
eager kindleBOT
GG @late eagle, you just advanced to level 1! Chat more to level up and earn top roles!
late eagle
@proud pilot you know what, I never cleared codes after replacing the battery and doing the reset procedure like the next day or a couple hours later or something, maybe I should try that
proud pilot
Take it to a shop or dealer.
drowsy bear
These new computers freak out over the tiniest issues like a dead battery. You'll need a more complex diagnostic tool to properly clear those codes.
A dealer will definitely be able to do it. But even a large reputable shop should have the equipment.
They will probably charge you one hour labor. So depending on the going rate where you live, it shouldn't be too bad.
azure spade
Literally just clear those codes and drive it
azure spade
Thats what it showed after "clearing"
Actually clear those codes with a good battery in it
If you don't have a scanner than can clear stored codes most modern Ford's will do it for you after you drive 50 miles or so
