i usually keep on 144hz and my native resolution for everyday use. when i launch some games i have to lower my refresh rate by going to display and to change refresh. very annoying to do because after when im done with gaming i have to change it back to 144hz
#my monitor native refresh rate is 144hz but genshin impact capped at 60hz...
mossy shore
i have an nvidia 4070ti but i don't know where the settings on control panel or ge force experience
tender turtle
mossy shore
thank you
tender turtle
np 👍
tender turtle
try the normal one first yes
hollow hare
The game shouldn't care about the refresh rate. It will just output a framerate
tender turtle
techically yes but i too experienced flickering when being capped (i have a 180hz monitor)
this fixed it
hollow hare
It might tear, but it shouldn't flicker.
mossy shore
The game shouldn't care about the refresh rate. It will just output a framerate
the game feels less smooth when my fresh rate is set higher. i can definitely see it
feels like 30fps when i have my native 144hz on
hollow hare
The monitor doesn't have fresync or g-sync?
mossy shore
yeah i have g sync on
hollow hare
What is the G-Sync range?
mossy shore
idk where to look for g sync range
hollow hare
What model monitor is it?
mossy shore
it's a gybite ultra wide but i need to look up model
hollow hare
In Windows, if you open Display Settings, click Advanced Display settings, it should show the model
hollow hare
Ok, I found a forum post about the flickering
It's when it goes in and out of freesync. The freesync range is quite small so if you have that on, it will flicker when it goes in and out of it
The freesync range is the FPS range where freesync works
Lower or higher than this range and it doesn't work
I can't find any specifics about the default range because apparently you can change the range in third party tools.
mossy shore
now to think of it i used to have flicker but don't know. idk what i did
hollow hare
The manual does say that Freesync doesn't work below 100Hz, so that might be why it feels better at lower refresh rate
mossy shore
i see
hollow hare
Could you try disabling it and seeing if that does anything?
It would be under G-Sync in Nvidia Control PAnel (Not sure if you have to disable it on the monitor as well, in the GUI)
mossy shore
is it under set up g sync?
on my the monitor controls
i mean my buttons physically on the back of my monitor
i just disabled free sync premium
is that what was the issue?
brb
hollow hare
is it under set up g sync?
Correct, the check box there.