yeah thats typical with new systems
go into windows power setting then go to "Change what the power button does"
then you can set it up as you want from there
#PC immediately shuts down after pressing the power button.
thick dock
spring plinth
The problem is the system does not complete the post process to get into windows.
slow geyser
try re seating the rams?
spring plinth
Ok ill give that a try, I removed the GPU as I suspected a possible power issue.
shy seal
Are there any POST lights or boot codes on the board?
It should give some indication of where it's getting stuck
jade pagoda
Could be any number of things
spring plinth
Are there any POST lights or boot codes on the board?
Sorry question - are the lights on the MB? I don't see any cause the PC starts then 2 seconds later shuts down
serene orchid
You might have shorted your motherboard out or you have a bad PSU. Unfortunately it's really hard to say what the problem is. I had a similar issue a few years ago and had to replace my motherboard, but this can be a number of different things, there's also no guarantee any of your other hardware wasn't damaged from a short. That's rough.
slow geyser
Sorry question - are the lights on the MB? I don't see any cause the PC starts ...
i had the same kind of thing a while back. legit just took out EVERYTHING and then reseated everything a few times and it started working
or you could check that all the cables are connected properly to the psu first
although now that i look at the video it looks like the systems shuts down after the ram lights go on so maybe try different ram sticks if you have any?
spring plinth
Im starting to suspect short - this PC was fine for over 6 months
slow geyser
have you upgraded anything before it started this?
spring plinth
No nothing