Confused on mirroring blocks

[crisp elm]

Im trying to make a T-rex as a complete beginner, im currently making the toes but i can not the get the left and right toe to be exactly mirrored on both side when rotating them. Is there a way to make it so i can make smaller adjustments at a time?

[atomic jacinth]

Welcome to the help forum!

Please make sure to read #1029373817119838218 as it may answer your question!

Once your question has been resolved, please mark the post as closed by using the </close:1163944441741049897> command.

[crisp elm]

or is there a way to only rotate around the centr of the block and not the center of the 3x3

[opaque osprey]

Is there a way to make it so i can make smaller adjustments at a time?
Yes, there is:

[atomic jacinth]

FAQ

Blockbench: Precise Movement

To move/scale cubes in smaller increments than 1 you can hold the following key combinations:
-Shift: 0.25
-Ctrl: 0.1
-Ctrl+Shift: 0.025
If those default values are not to your liking you can change these incrementsin File > Preferences > Settings > Snapping

PS: If you want to allign 2 elements we suggest using the vertex snapping tool instead (see !faq vertex-snapping for more info)
Disclaimer: The modded entity format does NOT allow decimal cube sizes and neither does the Optifine Entity format if box-uv is enabled!

[opaque osprey]

You can adjust the pivot point of the elements to rotate them around different points.