#waoh
i lov
subtle pike
Thanks - primary focus was a white build, which is why I ended up spraying the GPU shroud & fans. Custom made RGB strips top and bottom edge of case (just inside glass) and a strip inside the GPU shroud (Ventus 3X models don't have RGB of their own) are all connected to iCUE via Commander Pro/Node Pro (total setup includes 1 each of Commander Pro, Commander Core (H150i AIO), Node Pro, Node Core)
Also got a K70 Mk2 SE keyboard with pudding keycaps on it and a G502 I'm respraying white
restive spindle
id be scared to paint anything i get
im not good at that..
and id be super picky if theres any small messups
i also want a white build so maybe minell look similat to yours :D
plush parrot
how did you mount the gundam though
subtle pike
how did you mount the gundam though
Small adjustable clear plastic arm, goes from fan mounting hole to back of figure (it has a specific mounting point for this purpose)
plush parrot
oooh nice
is this something custom or is it avalible on the marcet
i have an itx case now
but if i was upsizing
wouldnt mind sticking my barbatos into it
subtle pike
is this something custom or is it avalible on the marcet
It's the arm off a displaystand - something like this
restive spindle
is this something custom or is it avalible on the marcet
comes with the figure :)
subtle pike
comes with the figure :)
Not usually included with Gunpla kits in my experience (it's not a pre-made figure - it's a from a kit)
oblique crag
🧊
woeful prawn
Thanks - primary focus was a white build, which is why I ended up spraying the G...
How did you spray the gpu?
plush parrot
It's the arm off a displaystand - something like this
and then you screw it to the fan? using a fan screw? honestly good idea
subtle pike
How did you spray the gpu?
Shroud and fans were removed from the GPU heatsink, fans were removed from shroud (unscrewed the bases, removed sticker from front+back & clip to allow fan blades to be removed from hub), and the gunmetal parts were removed from the main shroud (dremeled out the plastic rivets). Masked the two triangular parts, masked the hub/axle on the rear of the fan blades, and sprayed a few light coats.
subtle pike
and then you screw it to the fan? using a fan screw? honestly good idea
actually it is a push-fit. there are two different hinge parts - one type for the head/middle and one for the base. the base part is larger, and I had to sand it down a bit to get it to fit into the mounting hole on the fan
plush parrot
ah nice