I've been using the poke-reader plugin to track both the seed and advances. Every guide I've checked says to get to where you hold up your starter of choice and then make a timeline from there, but all the guides say there's only 1 NPC there (there's not, it says 4) and I've been using Frame Range instead. I have tried aiming for some shinies as a test and have missed everything, unsure if it's that the frame I'm aiming for then hitting is wrong, or if I just suck at hitting it (I pause then manually advance until I'm on the frame then hold down A). What would be my problem, exactly? I didn't touch consider delay or target frame, in which the latter was checked by default, but I have no idea what that even means nor can I find anything on it easily since everyone uses the timeline thing. I've been using the frame range bc I want short wait times since I'm aiming for a female shiny. I've only done Gen 4 RNG stuff before this.
#USUM Starter RNG Help
tulip talon
worn grove
It's 1 npc
Reload the npc count or be sure to be at the last input
Frame Range : wrong since timeline
tulip talon
I don't know what you mean by reload npc count. Every single time it's been 4 NPCs at this point
I also don't understand your second comment
worn grove
Just reload pokereader
Also you can calc npc without indicator
If advancing state by state gives a +2
Then it's 1 and work with 1.
pliant veldt
i'm kinda having this type of issue as well.. might you be able to elaborate on these steps as well.. (I'm new to cfw..)
stoic ingot
i'm kinda having this type of issue as well.. might you be able to elaborate on ...
you have to hide it and pop up it again
tulip talon
Its still counts 4 NPCs even after hiding it
tulip talon
And trying to test the timeline thing, I put in 1 NPC but it was skipping over some frames when I set NPCs to 1, but then became correct when I set NPCs to 0.
