#pre calc
34 messages · Page 1 of 1 (latest)
What is your question?
intercepts at the x-axis and y-axis?
yes
x-axis means to set y = 0
y axis means to set x = 0
if you look at a coordinate system it makes sense
at the x-axis y is 0
and at the y-axis x is 0
ok I have another question not pertaining to this at all, which way easier then this. this post is technically for my shy friend.
I'm assuming your pretty good at multiplication
go on
when it comes to multiplication do you use a formula to calculate or do you memorize the multiples of each number up to a certain point?
you can memorize up until 20
(i do up until 12 iguess)
how did you go about memorizing them?
it starts with elementary
when you do it quite often through the years you just know
but logic helps too
logic?
like if i dont know 9 times 12, I do 12 times 10 in my head which is easy it's 120 and then I can subtract 12 which results to 108
give your shy friend either some table (he should learn at least up to 10)
or he should start some exercises where you decompose numbers into prime factors or factors
thx for this, imma screenshot this
know anything about this?
The question: A Ferris wheel has a maximum height of 235 feet and a wheel diameter of 220 feet. Find an equation for the wheel if the center of the wheel is on the y-axis and y represents the height above the ground.
draw the wheel
on a paper
equation for a circle is $(x-m_x)^2 + (y-m_y)^2 = r^2$
adonhs
if the diamter is 220 what is the radius?