Pedal calibration? | RaceRoom | Page 1

hallow hornet Sep 16, 2023, 2:28 AM

#

Any way to calibrate controller inputs?

About the pedals, they are a DIY project which register as an xbox one controller in raceroom. I tried using vjoy but raceroom is not recognizing vjoy devices at all it seems.

The problem right now is that the brake pedal (which registers as the left trigger) only uses half the travel distance, 50% brake registers as 100% braking ingame. The throttle (registers as right trigger) works perfectly fine.

Ingame settings, all deadzones to 0%, sensitivity all set to 50% as they should.

Raceroom is the only sim where I have this problem...

native timber Sep 16, 2023, 5:57 AM

#

have you tried calibrating with diview

hallow hornet Sep 16, 2023, 6:39 AM

#

native timber have you tried calibrating with diview

Yes, when I press the brake pedal it's showing the input at the right level on diview.

But then I hop into raceroom and the brake pedal only uses half its travel distance. 50% input is 100% brake power

#

Tested on RF2, ACC, AMS2, iRacing and AC. They all work fine, just raceroom doing its own thing here 🤔

#

Think it has something to with xbox controller support? RaceRoom does the same thing when I test using an actual xbox controller.

native timber Sep 16, 2023, 6:46 AM

#

rebind the pedal

hallow hornet Sep 16, 2023, 6:46 AM

#

Did that

#

It's like it's not splitting the axis correctly as they are seen as combined.

Fix is to use vjoy but raceroom does not detect these devices it seems 😕

hallow hornet Sep 16, 2023, 8:54 AM

#

Managed to get vjoy to work. My pedals now work as they should 👍

#Pedal calibration?