#N3DS stuck moving
1 messages · Page 1 of 1 (latest)
🥺
If its not the digitizer its the circle pad drifting?
Try spraying compressed air into the pad
Or u could try to disconenct the digitizer and see if it still happens, then disconnect the dpad and circle pad respectively
W cstick with the thinkpad nip btw
I replaced the entire circle pad as well 😞
The dpad?
Like the arrows?
Actually
What if its the thinkpad nip
Try removing it (i guess u can remove it from above right?)
My bad
Mb for the misunderstanding about doad and cpad, ur best bet would be to try to remove the cstick nip, see if it works, if not disconnect the whole cstick module and see if it works.
I also replaced the c stick ..
Like brand new module
Brand new digitizer
Brand new joystick
ðŸ˜
remove the nub tho
like try turning it off, take off the nub, then turn it on
I also replaced the nub if that matters
But yeah still does it
I think it might have something to do with the joystick... But idk what to do about it. I tested on another 3ds I have by holding the joystick to the top left and it gives me the same results as from the issue 3ds
Actually nvm I take that back
It follows the same pattern if I hold the d pad as well
But I think it's still probably the joystick cus the console doesn't respond to it at all
is it modded at all? its not the same issue but my touchscreen was just completely fucked about a month ago, changing digitiser did nothing, was gonna remove cfw as a last resort cause i had no clue what was up, but i had to restore a nand backup from when i first modded it and that ended up fixing it. if you're at the point that your gonna get rid of the console may aswell just try resorting backups/potentially removing cfw
Not modded sadly. Wasn't able to get through setup due to this issue