Resin leaking out of print

[lyric vale]

So, I was painting a model that has been resin printer, washed, and cured and as I was painting, resin started leaking out from inside from a crack. The print was sitting for a good month or two before I started painting it, so I am not sure exactly what is going on. We ended up throwing it away, but here is another one doing the same thing.

We are using a Anycubic Photon M3 Max with Anycubic standard resin + and I'm priming with rust-oleum primer grey and painting with Citadel paints.

[dusty tinsel]

Did you try asking in #3dprinting ?

[lyric vale]

I have not. Others say it might be the primer, so I asked here first.

[shy girder]

Looks like uncured resin that was trapped in a hollow area. Are you hollowing your prints and putting drain holes ?

[lyric vale]

This one is solid with no drain

[shy girder]

Possibility that uncured resin was trapped in an empty cavity. What slicer are you using? I use Chitubox which now can detect them. You can hollow the print and add drain holes so that way the uncured resin is washed out

[lyric vale]

I'm using anycubic slicer for now.

[shy girder]

Haven’t used that slicer. I have a phrozen sonic mighty and use Chitubox

I would reprint, hollow and add drain holes

You can save the plugs from adding drain holes and use them to plug the holes

[lyric vale]

Oh, interesting

[shy girder]

You can also use uv putty with a uv light to plug the wholes

[lyric vale]

Oh okay!

I will start to do that for now on

Thank you

[shy girder]

No problem!

[lyric vale]

Should I keep this open or close this post?

[shy girder]

You can see a couple of the holes on the print, more all over.

[lyric vale]

Ah yes

[shy girder]

Plus you will save on resin

Let me know how it goes

[lyric vale]

Will do!