How do I Get a a signal to only trigger in a pulse, and not have it do a continuous signal?

[manic forge]

I'm trying to figure out how to Get a Cv1 circuit to trigger only once. (E.g A enemy spawner that will only signal once instead of continuously)

[full tiger]

#907325098799812608

[manic forge]

@full tiger 💀💀 The only reason I did it here is Because nobody pays attention to #907325098799812608

[full tiger]

you are asking Cv2 users how to use Cv1, despite the fact they having nothing to do with each other

the reason people pay more attention to Cv2, is because Cv2 is better than Cv1, and easier

[manic forge]

😱

[trail light]

There are some other ways to do it.

But

The easiest I find is to use a state machine. Your main signal will trip the gate between the two states. And wire desired single signal to the on enter pin of the second state.

[timid bane]

If its a trigger volume sending the signal you can configure the trigger volume and set "triggers once" to true.

[frigid basin]

plug the signal into a multiply chip and multiply it by 1 when you want it enabled and 0 when you want it off. There are many other options though such as a trigger volume and a button