random lake
what can i do to vastly reduce/stop pla/petg from oozing out before a print while warming up the nozzle?
depends on how high the nozzle was from the previous print it can get really long, like 10-20cm line oozed out which means i cant just print and forget about it until the print actually starts (which also locks me out of getting remote printing through wifi while not home)
what can i do? i'm on a sovol SV06+ using orcaslicer
rough knotBOT
white smelt
what can i do to vastly reduce/stop pla/petg from oozing out before a print whil...
Dry filament oozes less... But if you check your start gcode and make it so that nozzle heats after the bed it should reduce stringing to a point where a good purge line or skirt should keep it out of the way.
I would caution against starting prints while not at home unless you can also remotely stop it and adjust z offset accurately. (and also a camera)
random lake
Dry filament oozes less... But if you check your start gcode and make it so that...
drying filaments takes soooooo long 😭
white smelt
drying filaments takes soooooo long 😭
Yeah ik ik...but recovering from the resulting failed prints takes longerrrrrr 🫠
It is more tolerable with a dryer or dehydrator.