Hey, I am trying to use orca slicer with my qidi q2, but it doesn't use the nozzle wiper. every print it goes to do the purge line, but then it goes back to where it flushes the filament just to hang there for a few seconds doing nothing. after that it starts the print which then fails most of the time because the nozzle has a blob hanging under it. is there any way to fix that?
#Qidi Q2 orca slicer
fossil briar
silent heart
Hey, I am trying to use orca slicer with my qidi q2, but it doesn't use the nozz...
are you on the latest firmware on your q2?
fossil briar
yes
silent heart
okay, you need to downgrade lol
fossil briar
downgrade?
silent heart
yes, there's a problem with the latest firmware
fossil briar
i see
silent heart
there's a guide on the qidi discord on how to do it
fossil briar
but then why don't i have the same issue with qidi studio?
silent heart
could be that it was previously connected and the connectioned stayed after the update
even so, i would advise you to downgrade, for other reasons too
fossil briar
alright
could you point me to the guide? i joined the dc but don't see it
might be overlooking it completely😅
silent heart
could you point me to the guide? i joined the dc but don't see it
#1406085843772248158 message
fossil briar
ty