Ghosting of outline of interior hole showing on exterior | 3D Printing | Page 1

uncut sundial Jul 9, 2026, 2:55 PM

#

I'm making this pair of rings that have a hidden magnet to link them, but I can't get rid of the ghosting of the walls of the hole for the magnet showing on the outside. Tried making the gap between the wall 1 perimeter in width, as well as 2 perimeter in width, which is the one in the photo. 2 perimeter helped a bit, but not fully. I've tried switching to exterior perimeter first, but that didn't seem to do anything. Could it be a shrinkage issue causing the hole to ghost? What can I try to get rid of the ghosting? This was done on a p1s with gold silk filament from amazon.

gleaming topazBOT Jul 9, 2026, 5:00 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

uncut sundial Jul 9, 2026, 5:01 PM

#

Anyone have any ideas?

gleaming topazBOT Jul 9, 2026, 7:05 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

livid geyser Jul 10, 2026, 7:18 AM

#

uncut sundial I'm making this pair of rings that have a hidden magnet to link them, but I can'...

3 walls might it fully go...where do the seams sit?

#Ghosting of outline of interior hole showing on exterior