Blobs and strings on prints.

[honest wing]

Bambu P1S, PLA or PETG , 60% infill gyroid for the PLA neon green print, 0.4mm nozzle, bambu studio.
Blobs and strings of fillament appear on certain parts of the print. This issue appeared in my latest prints, but before the prints were alright. What is the problem and solution

[smoky pewter]

Try drying the filament

[potent topaz]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[karmic sail]

Could be that you need supports there too if filament is dry.