Ideas for a 3D printed box

[marble hare]

Hi everyone,

I want to make a box that contains my Raspberry Pi 5, the LCD screen, maybe 2 or 3 buttons, and my 5x7 cm perfboard.
The camera goes through the hole in the perfboard, and I attach it with screws. On the right side, I have a flat ribbon cable to connect the camera.

I am not sure how to design the box and where to place the screen. Should I put the perfboard behind the Raspberry Pi? I also need holes for the LEDs, and maybe holes or a window for the screen.
I am looking for advice or design ideas. Thanks!

[oblique heart]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[autumn jay]

it looks like..? do the standoff holes on the raspberry pi match up with the ones on the perfboard?
cos i'd probably stack em with some standoffs. you'll want intake and exhaust holes for the heat sink and etc as well possibly...

i'd get some cardboard, scissors and tape and and make a really rough proto-type to visualise + check cable lengths and etc.
there might already made stls for the pi and screen you can use for measurement to work off when you take it into digital