Creality PETG wouldn't fit 3d printed spool | 3D Printing | Page 1

civic zinc Apr 30, 2026, 3:47 AM

#

I bought 4 kilos of this creality PETG but when i tried printing the spool it doesn't fit in, i tried brute forcing it but the brown spool got completely entangled (and i threw a tantrum for a while about it) and i cannot find another model that would fit the filament all spools seem to have the same size. any tips i could use for the other 3 spooless filaments that aren't screwed up?

remote pawnBOT Apr 30, 2026, 5:50 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

exotic trench May 1, 2026, 8:22 AM

#

civic zinc I bought 4 kilos of this creality PETG but when i tried printing the spool it do...

Wondering if it'll fit if you take out the cardboard middle piece? Check it's not stuck to the roll first of course.
Note: i've never used these, so follow this advice at your own risk.

#

Do the replacement spool also screw together without the filament on it? (Aka. maybe tolerance issue?)

#Creality PETG wouldn't fit 3d printed spool