#prints not sticking to plate

1 messages · Page 1 of 1 (latest)

flint kiln
#

bambu a1 mini - Sunlu PETG filament
ive had some issues with my prints not sticking to my plate, i tried everything i could find online - cleaning the plate and calibration. finally raising the temp from 60 to 80 worked. however, today it started messing up again, but its different from last time, the thin corners of the prints bundle up into a mess of plastic, but the print doesnt full on unstick like it used to, i have provided a screenshot of an errand piece. the rest of it printed with no issues, apart from that corner. does anyone have any tips that could solve this issue or whats causing this to happen?

IMG20260416140100.jpg IMG20260416140051.jpg
rose forge
#

is there a draft where you are? like some cold air?

dull briarBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

flint kiln
#

its inside my house

#

ig it is near a window? but its not open

rose forge
#

hmm. did you try running a temp tower? what temp are you printing the filament itself at?

#

your print looks kind of matte, you may need to increase the nozzle temp

flint kiln
#

nozzle temp is 245

#

thats the default

#

rn its printing fine, i added some tiny supports to each of the thin sides and its okay

#

but its annoying

#

cuz i never know when itll fuck up again

flint kiln
#

im quite new to 3d printing

#

maybe i should consider moving the printer to a less open area?

#

the hallway its in is quite open

rose forge
#

that might help. basically the layers aren't bonding well, which is typically a heat issue. either cooling too fast or the filament isn't hot enough.
i'm trying to find a decent article on temp towers

flint kiln
#

thank you 🙏

rose forge
flint kiln
#

ill have a look at this, thanks a lot

rose forge
#

sure thing