#Printer shuts off before I can start a print

1 messages · Page 1 of 1 (latest)

peak flax
#

I know the title might be a little vague but, I have an Ender 3 pro with a Big Tree Tech SKM v3. My printer was working before one of the fans got caught during a print, it got ripped off along with my Bl touch. I’ve got all the mechanical parts replaced. When I turn the printer on it says no printer detected and if I try to use it like heat the bed or move it with the screen. The screen will go dark but I can hear the power supply fan still running

IMG_8138.jpg
harsh leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

peak flax
#

I have swapped the fuse on the motherboard to see if that would help

harsh leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

peak flax
harsh leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

modest harbor
#

It's not detecting the thermistors either. 🤔
Was the firmware loaded onto the bigtree tech by you for your printer?

harsh leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

peak flax
hardy lily
#

I have limited experience with Big Tree Tech, but I would double check that the "event" didn't do something to the connections on the board

peak flax