#Cura wont load hole

1 messages · Page 1 of 1 (latest)

compact quest
#

So, my model has a hole going through it since it'll have a rod support, but some reason Cura wont load the hole, while Bambu and Orca slicer do. there's a sizable gap for a connecting area but it fills it up and I have no idea why

image.png image.png image.png
polar crownBOT
#
AI Help

It sounds like Cura may be filling in the hole due to its settings or processing methods. You can try adjusting the "Fill Gaps Between Walls" setting in Cura to see if that helps preserve the hole in your model. Additionally, make sure your model is manifold and doesn't have any issues that may be causing Cura to fill in the hole. If the issue persists, you may want to reach out to the Cura community for more specific help.

WARNING: This response is AI generated and may contain errors.
polar crownBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

polar crownBOT
#

What is Manifold Geometry
It is important that a model's mesh is manifold in order for a slicer to accurately determine where to generate a tool path to print plastic and where not to.

In relation to 3d printing a model is manifold when you could imagine filling the entire internal volume with water from one source. In practice this means that the model mesh has one single shell with no other shells that overlap or intersect with one another and the shell has no holes in it and the mesh has no flipped normals. You can think of a shell like that of an egg shell, it encloses a single volume of space. If there is more than one shell then filling any one shell the fluid cannot reach the other shells. If shells are nested within one another completely then the volume between the two shells can be filled. If shells partly overlap then only some of the volume of one or both of the shells can be filled. If shells have holes or flipped normals then the volume will leak water.

?manifold requested by: wolfesbluebox#0
floral karma
#

if repairing through the auto repairer doesn't work, try manaully through blender with 3d print toolbox.

crisp umbra