Need help in the Slicer UltiMaker Cura 5.11.0

[thick blade]

So i want to print an RC jet but i need some slicer configs for it to be right. These are the settings:

1 wall!
2 top 2 bottom layers
3% grid infill

I've set it up in the slicer with help of ChatGPT but when im actually printing it the piece is brittle not smooth and feels like it will fall apart. ChatGPT told me when i changed the wall and layer settings i had to adjust the fan speed and print speed etc... Could that be the issue ?

[faint yoke]

AI Help

Yes, adjusting the wall and layer settings can affect the print quality, especially if the fan speed and print speed are not adjusted accordingly. To prevent the piece from being brittle and falling apart, you may need to tweak the fan speed or print speed to ensure proper layer adhesion and cooling. Additionally, make sure your filament is of good quality and your bed level is correct. Experiment with different settings until you find the optimal configuration for your RC jet.

WARNING: This response is AI generated and may contain errors.