#AMS filament loading issues

1 messages · Page 1 of 1 (latest)

modern fiber
#

In short, I dried filament for around 15 hours straight, the AMS was working fine before that and after the drying it doesnt. I think i narrowed it down to the yellow gears, i checked most things but everything looks fine. It tries to pull in the filament and does a little, then just fails and makes angry AMS noises, very loud too.

Screenshot_20260202_142135_Bambu_Handy.jpg
hollow irisBOT
#
AI Help

It sounds like the issue may be related to the extruder gears or possibly a clog in the nozzle. Here are a few steps you can take to troubleshoot:

  1. Check the extruder gears for any signs of wear or damage. If they look fine, try cleaning them to ensure there is no debris causing them to slip.
  2. Check for any clogs in the nozzle by manually feeding filament through the hot end. If the filament has trouble passing through, there may be a blockage.
  3. Check the tension on the extruder gears to make sure they are gripping the filament properly. Adjusting the tension may help with feeding issues.
  4. Ensure that the filament is loaded correctly and that there are no tangles or knots causing feeding issues.

If you continue to experience issues, consider reaching out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
tropic comet
#

Hello

#

Which printer are you using?

#

Try the connector to the ptfe tubel

modern fiber
modern fiber
tropic comet
#

Lube it?

hollow irisBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

modern fiber