Using SUNLU filament on my Flashforge Adventurer 3

[leaden schooner]

Just wondering what settings people have used for using SUNLU filament on an adventurer 3.

[grizzled wigeon]

AI Help

For SUNLU filament on the Flashforge Adventurer 3, a good starting point would be to use a nozzle temperature between 200-220°C and a bed temperature of around 50-60°C. It's also recommended to use a print speed of around 30-60 mm/s. Adjust these settings based on your specific prints and the results you're getting.

WARNING: This response is AI generated and may contain errors.

[grizzled wigeon]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[potent cloud]

For pla, stick to the lower end of temperatures. So 190 - 200
I've not used sunlu, but esun, siddament + protech pla go better at lower temps, due to adventurer 3's lack of heatsink and any real cooling.

Use a skirt and take your time levelling the bed + nozzle (setting calls it extruder height, but that's not the extruder)
If it clicks, you're too close.