Leveled my 3 times cleaned with dish soap twice the print still does in a couple of spots.

[rancid bobcat]

AI Help

Hello! How can I assist you with your 3D printing questions today?

WARNING: This response is AI generated and may contain errors.

[lusty fog]

your nozzle is too far away it seems

[rancid bobcat]

Z-offset

Where your printer thinks the nozzle is

The z-offset is the distance from the tip of the nozzle to the trigger point of a bed sensor.

Setting your z-offset correctly ensures a good first layer squish and proper adhesion to the build plate (assuming its clean, see
?bedcleaning for more information). See
?leveling for a good representation of how the first layer should look like.
If in doubt: Refer to you your specific machines documentation.

For the Qidi X series printers: Adjusting the z offset from the Fluidd webinterface breaks it. Always set the z offset from the printers screen.

https://www.wevolver.com/article/z-offset-what-it-is-and-how-to-adjust-it

?z-offset requested by: m.von.d#0

[radiant basin]

any closer i get elephants foot

[lusty fog]

elephants foot compensation is there for a reason

[radiant basin]

trying again

[radiant basin]

still the same if i go too low the frist layer gets sqished and tried with glue sill looks the same

[rancid bobcat]

?zoffset2 requested by: m.von.d#0