I got a printer off of marketplace and have no prior printing experience | 3D Printing | Page 1

prisma zenith Jan 20, 2026, 4:41 AM

#

I got told I need to manually raise the Z axis by turning the long screws in the back that make it go up and down but idk where the screws are. I got told it was there but I don’t see long screws.

pseudo idolBOT Jan 20, 2026, 4:41 AM

#

prisma zenith I got told I need to manually raise the Z axis by turning the long screws in the...

#

AI Help

The long screws that adjust the Z-axis height are typically located at the back of the 3D printer, near the base of the platform where the print bed sits. They are usually threaded rods or lead screws that you can turn to raise or lower the Z-axis. Make sure to power off your printer before attempting to manually adjust the Z-axis. If you are still having trouble locating the screws, consult your printer's manual for specific instructions on how to access and adjust the Z-axis height.

prisma zenith Jan 20, 2026, 4:42 AM

#

#

Nvm I figured it out my bad

#I got a printer off of marketplace and have no prior printing experience