#printer is 3x slower

1 messages · Page 1 of 1 (latest)

hardy mortar
#

i just started using my x1c again and was gonna do a benchy to make sure everything was working well but the print time is an hour which i know in the past was 25 mins and my friends with an x1c and online(https://forum.bambulab.com/t/what-is-a-realistic-time-for-a-benchy/87006) says it should be 25 mins

it seems i have all the default settings and nothing is red

image.png image.png
Bambu Lab Community Forum
What is a REALISTIC time for a benchy?

I have seen some insane videos of people doing a benchy in under 3 minutes… But I have not seen a speed benchy done with the recommended defaults and realistic quality. I am asking as I finally got my hands on an Obxidian hotend. So far it seems the things just outperforms any flow rate test that is not optimised for those high flow hotends...

waxen wraithBOT
#
AI Help

It's possible that there may have been changes in the slicing software settings or the model itself that could be causing the increased print time. Here are a few steps you can take to troubleshoot the issue:

  1. Check the layer height and infill settings in your slicing software. Lowering the layer height or reducing the infill percentage can sometimes increase print time.
  2. Verify that the print speed setting in the slicing software is set to the same value as before.
  3. Ensure that there are no additional supports enabled that may be adding to the print time.
  4. Check the slicing software for any other advanced settings or features that could be affecting print time.

If you've checked all the settings and are still experiencing longer print times, you may want to try slicing the Benchy model with a different slicing software to see if the issue persists.

WARNING: This response is AI generated and may contain errors.
polar galleon
#

tbf around 1 hour is normal for a benchy
sadlly there are not enough informations provided to give any advice why its not faster

hardy mortar
#

it should be 25 mins

#

i can send all the settings in ss

#

buts nothings red so idk

polar galleon
#

rn its like reading a magic ball on what the issue could be

#

but yea its quite likely one of these settings:
speed
Accleration
jerk
layertime

#

200mm/s at 10k accel and like a jerk of 10 should give you around 25mins if its not slowed down by a to small layertime limit

hardy mortar
#

im just dumb as rocks

#

i just switched to .20mm standard

polar galleon
#

tbf 0.2mm layerheight is what you want for a official speedbenchy

hardy mortar
#

it was already 0.2mm
comparing the 2 settings

#

it seems it was the inner and outer walls

#

in this one its set to 400 mm/s

#

but the other one was only set to 60 mm/s

#

?solved