My 3D print keep slipping off the buildplate

[noble goblet]

I use the elmers glue trick, should I increase the heating of the printer bed?

[deep hatch]

AI Help

Yes, if you are using the Elmer's glue stick method for bed adhesion, increasing the bed temperature slightly can help improve the bond between the print and the bed. Just be cautious not to set the temperature too high, as it can cause warping or other printing issues.

WARNING: This response is AI generated and may contain errors.

[pulsar wagon]

Ive never needed to up the temp for glue personally, but you could try

[stark stump]

What bed temp \ nozzle temp atm?

I usually avoid glue, cos i've had it warp a few prints... But if you dont have auto bed levelling, then it's a way around that i think?

Z offset could be another thing to investigate here.