#Overhang walls slicing and Silk PLA

1 messages · Page 1 of 1 (latest)

rotund grove
#

So i printed out this model after applying my supports and for some reason only the long sweeping overgangs on round surfaces just fell off for some reason. Similar overhangs near the ears and belts look great. I played with the slicer a bit and without setting the ~25% overhang to like 300mm/s it still wanted to slow down in those areas to ~27mm/s and cut flow? I really am at a loss for why it is behaving this way. I will show pictures of the slice soon.

20251203_220925.jpg 20251203_220921.jpg 20251203_220929.jpg
alpine sundialBOT
#
AI Help

It sounds like you may be experiencing issues with cooling, causing the filament to droop or fail to bridge properly on those specific overhang areas. This can be improved by adjusting your print settings related to cooling, such as increasing fan speed or reducing printing temperature for better layer adhesion. Additionally, make sure your support structures are optimized to adequately support those challenging overhangs. Feel free to share the slice pictures for further analysis and recommendations.

WARNING: This response is AI generated and may contain errors.