#my delta

1 messages · Page 1 of 1 (latest)

orchid plover
#

i dont really know how to setup endstop phase its not very clear from what ive found, i have a ramps 1.4 with klipper

queen stratusBOT
#
AI Help

To set up endstop phase on a Ramps 1.4 board with Klipper firmware, you can follow these steps:

  1. Locate the wiring pins for the endstop on your Ramps board.
  2. Connect the endstop to the correct pins, making sure to wire it correctly.
  3. In the Klipper configuration file, set the correct pin assignment for the endstop.
  4. Use the Klipper G-code commands to test and calibrate the endstop function.

If you need more detailed guidance or have specific questions, feel free to ask.

WARNING: This response is AI generated and may contain errors.