#Layers Seperating

1 messages · Page 1 of 1 (latest)

chilly goblet
#

Why are my layers so fragile? The layers are just peeling apart. I’m using a dremel digilab. Lowkey not the printer I would prefer to use, but it is what my work has. Also the prints are nearly impossible to remove from the build plate. Any suggestions would be wonderful. Thank you

IMG_9884.jpg
summer pulsarBOT
#
AI Help

It sounds like your print adhesion may be the issue causing the fragile layers and difficulties with removing prints. To improve adhesion and prevent layer delamination, you can try adjusting the bed leveling, increasing the bed temperature if possible, using a different build surface (like a PEI sheet), applying a suitable adhesive like glue stick or hairspray, or using a brim or raft for better bed adhesion. For easier print removal, consider using a spatula or scraper tool to carefully lift the print off the build plate. Regularly cleaning and ensuring proper maintenance of the build plate can also help with adhesion and removal issues.

WARNING: This response is AI generated and may contain errors.
twin charm
#

what material. and is it dry

#

and what temps are you printing at

chilly goblet
#

It’s pla and I have it in this filament dryer. It says 22%

IMG_9885.jpg
#

I’m printing at 220 degrees on my nozzle temp and 45 on my bed temp

twin charm
#

is your flow properly tuned?

chilly goblet
#

How would one do that?

twin charm
#

calibrate the esteps is step 1

#

step 2 is to do flow tuning in the slicer

chilly goblet
#

What are the esteps?

twin charm
#

it could

#

also be a clogged nozzle

twin charm
chilly goblet
#

I should look into it though

twin charm
#

if you lookup your printer theres prob a tutorial online somewhere

chilly goblet
#

Okay

twin charm
#

if your getting under extrusion, which can cause layer seperation yes

chilly goblet
#

I’ll check it out thank you so much

twin charm
#

try changing nozzle first (or a cold pull)

#

see if results improve.