print keeps failing after a couple of layers, NOT adhesion issue

[sleek sage]

so im trying to print some monopoly houses and the first few layers go down perfectly and stick well to the bed. but then after that, i just get complete spaghetti. i was printing fine yesterday, so im really confused what could be causing this. i have tried printing multiple times, with the exact same failure every time

[remote shore]

AI Help

It sounds like you may be experiencing a clogging issue with your 3D printer nozzle. This can happen if there is a blockage in the nozzle preventing the filament from extruding properly. I recommend checking and cleaning your nozzle thoroughly to ensure there are no obstructions. Additionally, you may want to double-check your filament settings and temperature to ensure they are set correctly for the material you are using. If you continue to have issues, it may be helpful to reach out to the manufacturer of your 3D printer for further assistance.

WARNING: This response is AI generated and may contain errors.