Z-axis bent | 3D Printing | Page 1

quiet lintelBOT Nov 3, 2025, 12:28 PM

#

AI Help

I'm sorry to hear about the accident with your Photon mono m7 max. It sounds like the z-axis may be misaligned or damaged. You may need to manually realign or potentially replace the z-axis components if they are damaged. I recommend checking the manufacturer's guidelines for troubleshooting or contacting their customer support for further assistance.

wintry hazel Nov 3, 2025, 12:31 PM

#

flip everything 180 degrees and have the air purifier bend it back the other way 👍

#

this might be bad advice, so take with salt, but unironically i would just bend it back and hope it works

boreal zodiac Nov 3, 2025, 12:36 PM

#

wintry hazel flip everything 180 degrees and have the air purifier bend it back the other way...

This is the culprit. Should probably yeet these out the window. feelssobman But thanks. Will probably have to take it apart and hope for the best I can see how badly it's bent.

quiet lintelBOT Nov 3, 2025, 2:39 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

#Z-axis bent