Flash forge adventure 3 pro v2 bed leveling issue | 3D Printing | Page 1

shy knot Oct 26, 2025, 4:02 PM

#

On the normal calibration using the paper method i set it to 1.25 and on the autocalibration method i set it to 1.25. Once the autocalibration was finished it gave me 9 numbers one for each point on the bed. Idk what to even use those numbers for and have the right rear side of the bed is too high and there is no adjustment screws on this printer or the magnet bed. I used this as my bed leveling test print https://www.thingiverse.com/thing:6423547 Any help to solve this issue would be apricated.

Thingiverse

4 x 4 Bed Level test by Ninedko

This is an 4 x 4 bed level test. Use the results after printing to tram the bed after an auto bed level.I used this for my Creality Ender 3 v3 Se

vagrant hareBOT Oct 26, 2025, 4:02 PM

#

shy knot On the normal calibration using the paper method i set it to 1.25 and on the aut...

#

AI Help

It sounds like the autocalibration process on your printer provided you with a leveling map showing the deviation at different points on the bed. You can use this map to manually adjust the bed leveling at the specific points that need it. Without adjustment screws, you may need to consider using shims or other leveling methods to address the height difference.

Regarding the bed leveling test print you used, it's a good choice to help fine-tune your bed leveling. Make sure you address the high spot on the bed before attempting to print again. If you need further assistance, consider reaching out to the manufacturer for more specific guidance on leveling adjustments for your particular printer model.

shy knot Oct 26, 2025, 4:03 PM

#