is there a line of code i can put to make my printer level the bed and save it before i print

[gentle heart]

i have a sovol sv06 and im useing orcaslicer

[quick inlet]

AI Help

That's great to hear! How can I assist you with your Sovol SV06 and Orcaslicer setup?

WARNING: This response is AI generated and may contain errors.

[whole latch]

G29 under G28, and then can remove M420 S1

[gentle heart]

will it save?

[whole latch]

it wont, but then if you start another then it will just make another new one

you could also save/store settings on printer after the prints done if you want one saved

[gentle heart]

nah i want it to do it every time level the bed then save it

[gentle heart]

so is M500 is save/store?

[whole latch]

yeah, thats the code for it

the screen save/store is just running that

[gentle heart]

wdym?

[whole latch]

from memory, m500 is a onetime code, that then restarts the printer, dont want that in slicer start gcode

[gentle heart]

G28 ; home all axes
G34 ; fix z axes
G29 ; level bed
M420 S1 ;load mesh

so thats good?

or do i remove m420 s1?

[whole latch]

M140 S60 ; set bed temps
G28 ; home all axes
G34 ; fix z axes
G29 ; level bed

you want to probe the bed when its hot

[gentle heart]

M104 S150 ; set nozzle temp to 150

G34 ; fix z axes rise
G28 ; home all axes
G29 ; level bed

add the m140 s60 with the g34 or wit hthe m104 s150?

[whole latch]

M104 S150 ; set nozzle temp to 150
M140 S60 ; set bed temps
G28 ; home all axes
G34 ; fix z axes
G29 ; level bed

you can move the nozzle heating around, i like to have it after the G29, G28 has to happen before G34/G29

[gentle heart]

ok ill do that and thank you

?solved