ender 3 neo firmware help

[simple horizon]

hello I am a middle of the road novice in 3d printing soni apologize for the toddler version of my problem. I have an ender 3 neo I have removed the Bowden tube set up and replaced with direct drive. now that I have done this I realized the auto level feature is now misaligned and the sensor hangs off the side of the print bed when touching the stop. so now I assume that since I have removed these features I need to update my firmware to ensure proper leveling and orientation. can anyone advise how to fix this and if it is a firmware issue where do I get the correct one for what I have? thank you in advance.

[mortal elk]

AI Help

It sounds like you may need to update your firmware to properly calibrate the auto-leveling feature on your Ender 3 Neo after switching to a direct drive setup. You can typically find firmware updates specific to your 3D printer model from the manufacturer's website or the online 3D printing community.

To update the firmware, you will need to download the correct firmware version for your Ender 3 Neo and then follow the manufacturer's instructions on how to flash the new firmware onto your printer.

Alternatively, you can also check with the online 3D printing community forums for specific guides or tutorials on how to update the firmware for your particular setup.

Ensure to follow the instructions carefully and make any necessary adjustments to calibrate your auto-leveling sensor after updating the firmware. If you encounter any issues during the process, feel free to reach out for further assistance.

WARNING: This response is AI generated and may contain errors.