Hi, how can i make these models of my decks thicker to from 1.6 to 2mm without changing geometry ? Im a beginner so dont know much at all about 3d modeling
#Help with my stl file
heavy crescent
fallen fableBOT
Hi, how can i make these models of my decks thicker to from 1.6 to 2mm without c...
inner monolith
Hi, how can i make these models of my decks thicker to from 1.6 to 2mm without c...
In the slicer turn off uniform scaling and scale it in the appropriate direction until its as thick as you like
heavy crescent
@inner monolith would that be a good way to make sure geometry of my deck doesnt change such as angle of kicks or concave ?
also what would be a good way to change length of deck from lets say 100mm to 96mm without messing up said geometry
inner monolith
If you only alter thickness it should stay the same, lenght would involve stuff like cutting out the middle section of the board, stretching it and reattaching it (if you want to avoid remodeling)
heavy crescent
Where would scale option be here ? this is a bit convoluted for me right now
inner monolith
Wtf is that program?
heavy crescent
3d slicer is there a different one ?
inner monolith
Look above
heavy crescent
Ok so i tried with Cura, here are the screenshots i tried to untick uniform scaling but it absolutely messes up the geometry of nose and tail of the board as well as concave
here is default look
and here is when i try to make deck a bit thicker with "uniform scaling" unticked, it just messes up the geometry instead of making deck thicker
and that is the problem i have idk how to go about it really
fallen fableBOT
fallen fableBOT