#Filament tube stuck in the hotend

1 messages · Page 1 of 1 (latest)

obtuse cloak
#

recently got a Kodak portrait, and while trying to unjam the tube, some of the tube went through the heater, it can slide up but not down, what do i do ;-;

IMG_9211.jpg
maiden plinthBOT
#
AI Help

It sounds like the PTFE tube may be stuck in the hotend. Make sure the hotend is completely cooled down before attempting any fixes. You can try heating the hotend slightly to soften any filament that may be causing the blockage and then gently try to remove the PTFE tube. If that doesn't work, you may need to disassemble the hotend to properly remove the tube. Alternatively, seek guidance from Kodak's support team to avoid causing any damage to the printer.

WARNING: This response is AI generated and may contain errors.
vestal walrus
maiden plinthBOT
vestal walrus
#

One of those on the other side?

obtuse cloak
#

i think there is

obtuse cloak
#

?solved