need some help please

[fresh pumice]

about to print some things, not all at once, the big problem is the mask. ive had one fail so far and cant afford another, so please help me out and dont be afraid to ask for more photos. would you hit print?

[glossy tangle]

AI Help

I can definitely help you troubleshoot your failed mask print! Please provide me with more details about the issue you encountered and any photos you have of the failed print. Together, we can figure out what went wrong and improve your printing process. Let's get that mask successfully printed!

WARNING: This response is AI generated and may contain errors.

[hallow pike]

hmm so your worried abt it falling right?

the only solution i could probably figure out is add a raft and a brim for support on the bottom for such a small surface area

also make sure your supoports are good

and can i see the sliced file please

[fresh pumice]

Thank you for replying

Slicing right now

Eyes are tricky, not sure if they needed supports I just painted everything that was 45 degrees

These are old old settings when this happened but this was the first fail, I haven’t done another print since, I’ve changed a bunch of settings already

Definitely printing too fast to start with I think

And supports were practically fused with the model, could only remove the big ones

[bright cedar]

for the easy ones change first layer density to 100% and top z distance up, usually 0.2 is the starting point, but too low they fuse, too high they dont support

as well post how the first layers look, zoffset is still important when it comes to tall and skinny objects

[fresh pumice]

Thanks jack