when i put the filiment into the extruder, before it can come out it like curls around the bolt | 3D Printing | Page 1

polar magnet Sep 20, 2025, 4:55 PM

#

i cant get it to stop curling so it wont even come out of the extruder start of the tube thing, I had some people say i need to tighten screws and move it closer but i dont know where im lostt

twilit forumBOT Sep 20, 2025, 4:55 PM

#

polar magnet i cant get it to stop curling so it wont even come out of the extruder start of ...

#

AI Help

It sounds like you are dealing with issues related to bed adhesion and leveling. You may need to adjust the leveling of your print bed to ensure the correct distance between the nozzle and the bed. Make sure the bed is clean and try using a bed adhesive like glue stick or painter's tape. If the issue persists, you may need to adjust the extruder temperature or try a different filament. Remember, consistency in leveling and proper bed adhesion are key to successful 3D prints.

polar magnet Sep 20, 2025, 4:56 PM

#

Ender 3

#

Idk how to fix it

#

it keeps curling and wont go out

#

how do i make it stop curling?

twilit forumBOT Sep 20, 2025, 5:32 PM

#

Pong!

twilit forumBOT Sep 20, 2025, 7:36 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

earnest bloom Sep 21, 2025, 12:17 AM

#

polar magnet i cant get it to stop curling so it wont even come out of the extruder start of ...

There should be a screw inside of a spring. Pretty sure it's that one. But check this first:

twilit forumBOT Sep 21, 2025, 12:17 AM

#

earnest bloom Sep 21, 2025, 12:18 AM

#

Because too tight can also create non- extruding + black dust.

#when i put the filiment into the extruder, before it can come out it like curls around the bolt