#How can I increase tab strength

1 messages · Page 1 of 1 (latest)

zenith cradle
#

Hello I just printed this and the tabs all snapped right off with little to no pressure. Any idea what I can do to increase the strength or is this going to be a design flaw in the model?

I’m not the greatest at this. Just pretty good at downloading and printing things so let me know what settings you would change or if you need to know what I had things set at and I’ll provide.

Screenshot_2025-09-09_at_7.35.09_PM.png
indigo locustBOT
#
AI Help

Hello! It sounds like the issue may be related to the design or the printing settings. Here are some suggestions that may help strengthen the tabs:

  1. Increase the infill density: A higher infill percentage will make the tabs more solid and less likely to break. Try increasing it to at least 20% for better strength.

  2. Adjust the print orientation: Printing the object with the tabs oriented in a different direction may provide more strength. Consider printing the tabs vertically or with support structures for added stability.

  3. Use thicker layers: Increasing the layer height can make the tabs stronger. Try using a layer height slightly thicker than what you used for the rest of the print.

  4. Slow down the print speed: Printing at a slower speed can improve the overall quality and strength of the print, including the tabs.

If the issue persists after trying these suggestions, it may indeed be a design flaw in the model. In that case, you may want to consider modifying the desig...

WARNING: This response is AI generated and may contain errors.
zenith cradle
#

This is on an elegoo carbon and I’m using petg

hybrid viper
indigo locustBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

zenith cradle