Print quality, sorry for the Pic quality

[rich grove]

I've printed this before and the same exact issue happened on the same layer, kywoo tycoon slim

[junior lichen]

AI Help

It sounds like you are encountering a layer issue during your 3D printing. Possible causes could be incorrect layer height settings, an issue with the filament, or a problem with the printer's extruder. I would recommend checking and adjusting these settings to see if it resolves the issue. If the problem persists, please provide more details for further assistance.

WARNING: This response is AI generated and may contain errors.

[rose oar]

is the filament fuzzy?

[rich grove]

Fuzzy?

[rose oar]

like stringy. im trying to tell whats going on sorry

[rich grove]

Little bit of stringing on the print but the filament itself is normal

[rich grove]

Don't sweat it

[rose oar]

whats the exact issue in the picture?

[rich grove]

Better Pic

[rose oar]

ah got it. could be a z offset thing?

[rich grove]

Like bed leveling? I level my bed before everything print

[rose oar]

z offset is different than bed leveling a little bit

you gotta do it while you print.

[rich grove]

Alright

[rose oar]

theres a guide on adjusting the z offset one sec

https://ellis3dp.com/Print-Tuning-Guide/articles/first_layer_squish.html

this talks about the first layer but it sets it up to be a successful print

[rich grove]

Ok thank you, I'll try it tommorow and get back to you then

[rose oar]

Good luck! There's some other kinds of tuning that might also fix the issue there too.

[rich grove]

Last question for now, would you recommend using the guide you gave me or can I just use another video/guide if I find it easier to understand

[rose oar]

Id recommend this guide but if its hard to understand im sure there's a video out there about this.

[rich grove]

Ok thanks alot

[rose oar]

of course!