Ender 3 v3 se leveling problems | 3D Printing | Page 1

austere silo Sep 2, 2025, 12:18 AM

#

So every time I try to print something the nozzle dogs into the bed and I’ve already leveled it multiple times but it just keeps going into the print bed any ideas why this is happening

primal sparrowBOT Sep 2, 2025, 12:18 AM

#

austere silo So every time I try to print something the nozzle dogs into the bed and I’ve alr...

#

AI Help

It sounds like your nozzle may be too close to the bed. Try adjusting your nozzle height slightly farther from the bed and see if that helps. Additionally, ensure that your bed is heated to the correct temperature and that your print bed surface is clean. If the issue persists, you may need to recalibrate your printer's z-axis offset.

knotty gyro Sep 2, 2025, 1:10 AM

#

Are you able to adjust where your z offset is?

primal sparrowBOT Sep 2, 2025, 3:13 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

austere silo Sep 2, 2025, 7:04 PM

#

knotty gyro Are you able to adjust where your z offset is?

Yep already tried that seems to have no affect

#Ender 3 v3 se leveling problems