#Warped boards

1 messages · Page 1 of 1 (latest)

shut umbra
#

Hello, just got a few questions. As you can see, those opengrid boards are warped at the edges so are they usable? And how can I fix future prints?
Also my walls have steel studs so would it be fine to mount the snaps using self driving screws or is it better to mount into drywall using drywall anchors?

PXL_20250827_143810737.MP.jpg PXL_20250827_143537466.MP.jpg PXL_20250827_143849116.MP.jpg
upbeat karmaBOT
#
AI Help

Hello! Warping at the edges of opengrid boards can affect print quality but may still be usable depending on the severity. To prevent this in future prints, ensure the printer bed is properly leveled and use appropriate bed adhesion methods like a heated bed or adhesive sprays.

For mounting snaps on walls with steel studs, using self-driving screws should be sufficient as long as they are compatible with steel studs. If you prefer mounting into drywall, using drywall anchors can provide more stability. It's important to consider the weight and size of the object being mounted when choosing the method. Let me know if you need more assistance!

WARNING: This response is AI generated and may contain errors.
thorn raven
shut umbra
#

I did that yesterday, usually I use alcohol tho

thorn raven
#

nah, just wash it in the sink

shut umbra
#

Will do from now on

#

Those boards are still usable right?

#

They have a flex in the middle so I'm not sure if I should mount at all 4 corners to force the board to open up straight

#

Snap mount

thorn raven
shut umbra
#

Alright

upbeat karmaBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

mighty dome
upbeat karmaBOT
#

Warping can be a real issue, it can ruin the foundation of the printed part and its dimensional accuracy, leading to a potentially unusable part or a detached print.
Warping happens due to the shrinkage of plastic as it cools.

Here are some easy fixes:

  • Make sure that the buildplate is completely clean, refer to ?bedcleaning
  • Check if your bed is set to the correct temperature.
  • No or minimal part cooling for the first few layers, usually one or two.
  • Using a brim (or raft as a last resort) can ensure better adhesion to the buildplate.
  • Using an adhesive such as gluestick, hairspray or a specialized adhesive can be an easy and safe solution. This depends highly on the used buildplate material.
  • Be careful for ambient temperature changes such as opening doors, windows or the printers enclosure. A gust of cold air can throw off your temperatures enough to cause warping.
?warping requested by: wolfesbluebox#0
mighty dome
#

also air conditioning + heating vents.