#I don't understand

1 messages · Page 1 of 1 (latest)

tardy marlin
#

I have a sovol sv06 plus. It's been making some noise when the bed is moving in its midpath. I come back to a print and find it on the ground, the bed is very hard to move almost stuck. I take the belt off the bed stepper motor and the bed moves fine so seems like a bad motor. I leave the belt off for a few hours and come back to try again and the motor is working, no more noise and the printer is working fine and the noise is gone. I'm so confused.

obtuse streamBOT
#
AI Help

It sounds like there could have been some debris or obstruction causing the bed to get stuck. Removing the belt and allowing it to rest may have helped realign any components or clear out the obstruction. If the issue persists, it may be a good idea to inspect the motor and belt system for any signs of wear or damage. Consider lubricating the moving parts and double-checking the belt tension to ensure smooth operation. If the problem continues, reach out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
tardy marlin
#

Sv06 plus, marlin, no mods,

obtuse streamBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.